My Blinkies :)
Creative Fabrica
Creative Teams
Artists and Store I like
Nov 9, 2017
Lady Dragon Bonus
This tutorial is written in Corel X5 but any version
should work, it’s written in hopes you have a working knowledge of Paint Shop
Pro or other graphics program… This is not meant to copy or look likes your
work, if it does its purely coincidental and unintentional…
I am using a PTU kit
By Irish Princess Design
It’s a match to an older Arthur Crowe bonus tube
Called Lady Dragon
Make sure if you spend the $8 Dollars you specify if you want this Bonus tube, otherwise you get the current one..
Preview of the kit that comes with the tube
You can get the kit and tube combo
Here AC~LadyDragon Bonus
I am using a FTU mask by Dee
(DD_NFM_2015-4)
Open a 725x725 tag (you can size down later)
E1 c/p leave as it falls on the tag…
E2 c/p re-size by 85% pull to the left of doorway…
E50 c/p re-size by 85% pull to the right side of
doorway…
Take the close up 1 paste and re-size her by 40% pull
to sit in the middle of the doorway…
E4 c/p re-size by 60% pull to the bottom of the tube…
E33 c/p re-size by 70% pull to stand on the left side
of your grass…
E46 c/p re-size by 40% pull to the left hand edge of
grass
E7 c/p rotate 80° to the right re-size by 55% pull to
sit on top of the eggs…
E20 c/p re-size by 30% pull to the right side of
grass…
E35 c/p re-size by 25% pull to the left of rock…
E44 c/p re-size by 55% pull to the top of your
doorway…
Go to bottom of your tag re-size paper 10 to match
725x725 flood fill apply mask from above..
Go to the top most layer of your tag and add a new
raster layer for your copyright layer and credits to kit maker .. Add a saying
and your done..
© LadyDragus ~ November `2017
Tags for mask maker
Subscribe to:
Post Comments
(Atom)
Kit Match For
Stores I Sell At
Forums
Blogs I follow
.gif)
Blog Trains for HODG
0 comments:
Post a Comment
Thank you for reading my tutorials and snagging my snags. I design under House of Dragus Graphics by LadyDragus