Blue Perfections
By MMDesigns 

A walk through the Cemetery 

This tutorial is written in Corel 2023, but any version should work, this is written in hopes you have  working knowledge of Paint Shop Pro or other graphics program… this is written by me, never meant to copy or look like your work…

I am using a PUT tube
By Jasmine Becket-Griffith
Called A Walk through the Cemetery

You can get this tube
Here Through the Graveyard Tube

I am using the matching kit
By Moonshine Dezinez
Of the same name 

You can get the kit
Here A Walk through the Cemetery

I am using a FTU template
By Dino’s Digital Art 

Here Dino's Template

Leave it the size it is

Remove copyright layer and bottom white layer, and the border layer
Remove copy of layer 2, raster 3 and the layer promote selection
Raster 4 and copy of raster 4 flood fill with Paper 10
Raster 1 and the copy of raster 1 flood fill with paper 6
Raster 1 and it’s copy flood fill with paper 2
Take the tube we are using click on raster 1 paste the tube mirror then size it down by 50%
55 c/p size this down by 36% pull to cover up the bottom left of the tube, the top flower will look like it is lying on the skull in the tube
Click the layer under the tube,
61 c/p size this down by 50% pull to the upper right of that layer
Click on top most layer of your tag
86 c/p size this down by 35% pull to the bottom of the layer
36 c/p size this down by 39% pull to sit on bottom of the rectangle
37 c/p size this down by 35% pull to hover over the cross
51 c/p size this down by 29% pull to sit on the far right side of the tag
69 c/p size this down by 29% pull to sit on right edge of the cross
26 c/p size this down by 12% pull to sit at bottom of the book
17 c/p size this down by 35% pull to hang on the far left edge of the tag
84 c/p size this down by 29% pull to the middle of the moon
53 c/p size this down by 18% pull to sit on the left edge of the foot of the skeleton
23 c/p size this down by 15% pull to sit on the bottom of the thorns on the left side of the tag
62 c/p leave as this falls on the tag 

Add a new raster layer for your credits, for the tube and make sure you have a valid license to use her work, add a saying to the tag and your done.. 

Thank you for reading my tutorial 

©LadyDragus~26

Tags for kit maker, and temp maker

 I had the privilege to work with a kit 
By Charmed Designs