Oh Yes my General

This tutorial was written in PSP9, but any version should work

It is written On January 14 2014 out of my own design.

Any resemblance is not meant, or intended…

I’m using a PTU Scrap kit by Devilish Dezines

She sells at many stores you can find them

All on her blog

Here Devilish Dezines

I’m using the PTU artwork of Keith Garvey

He has his own store

Here Garv~Girl PSPTubes

Open a 610x610 Tag size

Frame2 c/p re-size by 55% you will pull the frame, up to the left a little bit to make your tube like she is leaning on the frame

Add a drop shadow of your choice to the frame

Element6 c/p leave in the middle of your tag, behind the frame…

Element43 c/p re-size by 50% mirror it and pull to the right hand side of frame…

Then take the copy of the re-sized version and flip it and pull it to the bottom of the left hand side of frame…

Element 15 c/p mirror the image, then re-size by 50% rotate 45º to the left pull to the bottom left hand side of the frame…

Element 41 c/p pull to the bottom of Element 15 rotate 45° to the left hand side of tag,

Take element14 and make a duplicate Layer of the element, clean off all of the ribbon, and paste that and add a sharpen more 2times to the element, and your drop shadow of choice

Take your tube and paste it as a new layer,

 The tube I’m using looks like she is leaning on a wall…

Element18 c/p re-size by 80% pull in the middle of her legs

Element 7 c/p re-size by 45% pull to the left hand side of the tag

Element 10 c/p re-size by 35% pull to the left hand side of skull, take a copy of re-size version and rotate 90°to the right, pull it even with the stem of the other cup

Element 40 c/p re-size by 30% pull it to the edge of the cups

Element 25 c/p re-size by 30% and pull to the left hand side of element 40

 Element 49 c/p re-size by 30% pull to middle of the other “toy” element

Add your copyright and a name on the tag and your done…