LadyDragus Art: Santa's Helper

Dec 6, 2017

Santa's Helper

Wednesday, December 06, 2017 | Edit Post

Santa’s Helper’s

This tutorial is written in Corel X5 but any version should work, it’s written in hopes you have a working knowledge of Paint Shop Pro or other graphics program… This is not meant to copy or look likes your work, if it does its purely coincidental and unintentional…

I am using a new PTU kit

By FwTags Creations

Called Santa’s Cookies

You can find all her stores listed

Here FwTags Creations Blog

Here main store

Here FwTag Creations Store

I am using the wonderful PTU

Artwork of Laguna

You can find the tubes

Here PFD~Laguna Tubes

I am using a FTU mask by
Moonbeams and Spiderwebs (MB-SW-76)

You can find them all here Moonbeams and Spiderwebs

Open a 725x725

Frame 6 c/p re-size by 73%

E8 c/p re-size by 40%

E82 c/p pull it to the bottom of your frame…

E31 c/p re-size by 60% pull to the lower right hand edge of your frame…

Take the version of the tube you wish to use paste her re-size by 31% sit her on the bottom edge of your frame… Take the cat tube mirror him and re-size by 23% pull to sit at the bottom of your tube…

E26 c/p re-size by 36% pull to sit in front of the tube…

E46 c/p re-size by 40% pull to the left side of your tag…

E9 c/p re-size by 25% pull to sit under the table…

E41 c/p re-size by 12% pull to sit on right edge of tree…

E43 c/p re-size by 12% sit by other present…

E22 c/p re-size by 12% pull to sit in front of other two presents…

E68 c/p re-size by 50% pull to the left of presents…

E23 c/p re-size by 21% sit him on very end of train…

E83 c/p re-size by 23% pull to sit under the right side of table…

E59 & 60 c/p re-size by 9% pull to sit on top of the plate…

E71 c/p re-size by 23% pull to the left of red bottle…

Go to bottom layer of your tag and flood fill with paper4 apply mask from above, merge into one layer move up to the top just a bit so it all shows…