Ah Mamma’s Trunk

This tutorial is written in Corel X5, but any version should work.

It is written out of my own thought’s never meant to copy, or look like others.

I am using a PTU Kit by

Whispy’s D’zines

She sells at a bunch of stores

You can find them all on her blog

Here Whispy's D'zines

I am using a FTU Poser by

Outlaw By Design

She also has PTU on her website

But this was offered as a free one

You can find out more

Here Outlaw By Design

#639 off her free things

When dealing with a full size image, you will need to make a smaller full size if you want to use that, and a close up so you can use it behind a frame if you want one…

I am also using a FTU Mask By

Rocked By Rachel

Here  Rocked By Rachel

(maskset13_1)

Open a 650x650 size tag

49 c/p re-size by 55% leave in the middle of your tag…

Take your close up mirror and re-size by 55% take the re-sized version of your frame paste over and clean off the top make it look like she is behind the frame, with some of her showing below the frame on the inside…

41 c/p re-size by 65% pull to the bottom of your tag…

26 c/p re-size by 55% pull to the lower left hand edge of your tag…

11 c/p mirror rotate 45° to the right and pull to the lower right hand edge of your tag…

18 c/p re-size by 40% pull to the lower left hand edge of your tag…

16 c/p re-size by 40% pull to the lower left hand edge of purple flower…

4 c/p re-size by 25% pull to the middle of your tag…

11 c/p re-size by 35% pull to the left hand side of trunk…

37 c/p re-size by 25% pull to make it look like it’s in her hair…

Go down to the very bottom of your tag flood fill with paper6 apply the mask from above, merge them into one layer, and up-size it by 110%

Then go back to the top of your tag, add a new layer, to add copyright and give credit to kit maker if she requires it.

Thank you for reading/doing my tutorial

©LadyDragus January 24 2015

Tag for kit maker and mask lady