Springs in the Air

(Or I hope it is)

This tutorial is written in Corel X5, but any version should work.

It is written out of my own mind and creativity, it is never meant to copy or look like others work.

I am using a PTU Scrap kit

By

Rissa’s Designs

Called

Perfectly Spring

She sells at a many stores you can find them all on her

Blog here Rissa's Designs

I am using a PTU Tube

By Verymany

This tube can be found in there store

Here Very Many Tubes

I am using a FTU Mask by Vix #362

You can find all of her goodies on her blog

Here VixPSP

Open a 700x700 size tag, you can re-size it later

 E36 c/p re-size by 85% leave in the middle of the tag…

Take the close up of the tube and paste as new layer, re-size her by 55% pull even with the bottom of the frame…

90 c/p flip vertical re-size by 90% pull to cover the bottom edge of your tube…

21 c/p rotate 45° to the right re-size by 80% pull to the far right hand edge of tag…

12 c/p rotate 90° to the left flip it vertical, then re-size by 65% pull even with the bottom edge of your tube…

60 c/p re-size by 65% pull to the far right hand edge of the flowers…

28 c/p mirror re-size by 60% pull to right hand edge of rose…

23 c/p re-size by 70% pull to the lower right hand edge of tag…

19 c/p re-size by 25% pull to the left hand edge of 23…

70 c/p pull to the bottom edge of your tag…

Go to the bottom of your tag

E38 c/p all over this layer I did it about 5 times to make it look like  a scatter of flowers..

Flood fill very bottom layer of your tag with paper8 merge the scatter down on to the paper, then apply mask from above or one of your choice, merge into one layer up-size it by 110% add a sharpen more to the layer and your almost done…

Go back up to the top most layer of your tag, add a new raster layer for your copyright for tube and kit maker if she requires it..

Thank you for reading/doing my tutorial

©LadyDragus~2015