LadyDragus Art: Autumn Spice

Labels CT Teams

Nov 8, 2018

Autumn Spice

Thursday, November 08, 2018 | Edit Post

Autumn Spice

This tutorial is written in Corel X5, but any version should work, this is written in hopes you have working knowledge of Paint Shop Pro or other graphics program… this is written by me, never meant to copy or look like your work…

I am using a PTU kit

By Joyful Kreationz

Called Autumn Margo

You can only find this kit at Scraps and Co.

Here Joyful Kreaitonz ~ Autumn Margo Kit

I am using a PTU

Bonus Tube from 2016 **for bonus tubes you must buy $8.00 then request the one you want, if not you will get the current tube that is up at the store**

By Arthur Crowe

YOu can find all of the stores Bonus

Tubes
Here Bonus Tubes Crowe's factory

Open a 725x725 tag (size down at the end)

Frame 5 c/p re-size it down by 75%

E43 c/p rotate 90° to the right, pull it to the far right hand edge of your frame…

E68 c/p pull to the left hand edge of your frame..

E19 c/p pull behind the frame, size it down by 40% apply these settings

Using MuRa’s Copies

Take the tube you are going to use, mind is a standing tube (Close up) Paste and I re-sized her down by 65% pulled to the middle of the frame; I also cleaned off any of the leg showing…

E72 c/p re-size down by 40% pull to sit on the left hand side of your tube…

E5 c/p re-size down by 60% pull to the far left hand edge of your tag, c/p mirror a 2^nd one to the right hand edge of your tag..

E36 c/p flip vertical re-size it down by 60% pull to the right hand edge of your tag…

E53 c/p pull to the bottom hand edge of the tube/frame…

E54 c/p size down by 85% pull to the lower left edge of your tag…

E33 c/p re-size down by 27% pull to the far left hand edge of your tag…

E14 c/p mirror size down by 45% pull to the right hand edge of the tag…

E62 c/p leave it as it falls on the tag..

I do not think a paper is needed since you really wont see it around the leaves we put and trees on the tag…

Make a new raster layer for your copyright’s and credit to kit maker, make sure you have LIC# to use this tube…

Thank you for reading my tutorial…

Tag for kit maker