Peaches and Cream

This tutorial is written in Corel X5, but any version should work. It is written out of my own mind and thought’s never meant to look like others.

I am using a PTU Birthstone kit

By

Gimptastic Scraps

She sells at a few store's, but you can find this exclusively

At The PSP Project

Here TPP~ The PSP Project

You can find the other stores she sell’s at

Here Amy&Leah Gimptastic Tuts

I am using the PTU artwork

Of

Barbara Jensen

You can find all of her work, in her store

Here  Barbara Jensen Tubes

I am using a FTU Mask by Vix (Vix15)

You can find all of her goodies

Here Vix PSP Madness

I am using the font Saffron Too

You can find this on most FTU sites…

Open a 675x675 size tag, you can re-size later

Frame 2 c/p re-size by 80%

Frame 1 c/p pull behind frame 2, up-size by 105%...

Rose scatter c/p mirror re-size by 70% pull to the left hand edge of your frame, some of your tube will cover these…

Tree c/p mirror re-size by 70% pull to the far right hand edge of your frame…

Bird c/p re-size by 55% pull to the top of the tree…

Take the close up tube, of this package and re-size by 70% pull to the middle of the frames…

Sticks c/p rotate 90° to the right pull to the left hand edge of frame, covering the bottom part of your tube…

Moon c/p re-size by 70% pull to the lower left hand edge of tube…

Ribbon c/p pull to the bottom hand edge of your frame, take the ribbon colorize it and paste a 2^nd time, mirror and pull to match up with the silver ribbon (yes Amy does allow colorizations of the elements in her kits)…

Cross 2 c/p re-size by 70% pull to the right hand edge of moon…

Angel c/p pull to the very bottom edge of your tube re-size by 75%…

Flower 1 rotate 45° to the right re-size by 65% pull to the left hand side of Angel…

Gem 1 c/p re-size by 55% pull to the right hand edge of paper rose…

Sparkle c/p pull to the right hand edge of your tag…

GO to the bottom layer of your tag, flood fill with paper 5 apply mask from above, I always add a drop shadow of choice to make the mask stand out better…

Go to the top most layer of your tag, add a new raster layer and your credit for the tube and kit if required, add what ever saying you want on the tag and your done…

Thank you

LadyDragus ~2015

Tag for Kit maker and tube artist