My Blinkies :)
Creative Fabrica
Creative Teams
Artists & Stores
Aug 16, 2017
Queen Monarch
This tutorial is written in Corel X5, but any version
should work, it’s written in hopes you have a working knowledge of Paint Shop
Pro or other graphics program… This is written by me never meant to copy or
look like others work…
I am using the stunning arwork
Andy Cooper Called
Queen Monarch
I am also using a matching kit
By Angel wings Scraps
You can find all of the Queen Monarch kits tube and clustesr
I am using a FTU mask by Rachel 149-1
Here Rachels Design
Open a 725x725 size tag you can size down later…
E60 c/p re-size by 65%
E13 c/p re-size by 55% pull the left hand edge of your
tag c/p mirror pull a 2nd to the right hand edge of your frame…
Take the close up of the tube paste and re-size by 45%
pull to sit in the middle of your frame…
E12 rotate 45° to the left re-size by 60% pull to the
bottom of your tube…
E39 c/p re-size by 45% pull to the lower right of the
tag…
E10 c/p re-size by 40% pull to the bottom of your
tube…
e1 c/p re-size by 40% pull to the lower left of your tag…
e1 c/p re-size by 40% pull to the lower left of your tag…
E19 c/p mirror re-size by 25% pull to sit on right
hand edge of the fox…
E22 c/p re-size by 20% pull to the middle bottom of
fox…
E36 c/p re-size by 20% pull to sit over the left hand
edge of fox’s head/ear…
E7 c/p re-size by 25% pull to the upper right hand
edge of the yellow plant…
E6 c/p re-size by 20% pull to sit on the orange
flowers on end of fox…
Go to the bottom layer of your tag flood fill with
paper2 apply mask from above…
Thank you for reading my tutorial…
©LadyDragus~ August 2017
Tag for mask maker
Subscribe to:
Post Comments
(Atom)
Kit Match For
Stores I Sell At
Forums
Blogs I follow
Blog Trains for HODG
0 comments:
Post a Comment
Thank you for reading my tutorials and snagging my snags. I design under House of Dragus Graphics by LadyDragus