New PTU now FTU kit 

By Me (DBLD) 

Hearts Discontent

I made a tag with the kit  for Digital Art Heaven

 Under the Sea

 

This tutorial is written in Corel 2023, but any version should work. This is written in hopes you have  working knowledge of Paint Shop Pro or other graphics program… this is written by me, never meant to copy or look like your work…

Good evening I am working with a PUT kit
By MMeliCrea Designz
Called Beach and Sea

You can get this kit

Here Beach and Sea

I am using the amazing artwork

Of Verymany

Using her tube Mermaid 5

You can get all of her tubes Here www.verymantubes.com This tube Mermaid 5

 Simone mask 0353
Here Scrappy bit of fun

Open 750x750

Frame 001 c/p size this down by 60%
5 c/p size this down by 32% pull to float above the boat
28 c/p size this down by 35% pull to the bottom right of your frame
3 c/p size this down by 45% pull to the middle of the frame( it will be covered up some later)
1 c/p size this down by 25% pull to sit in the middle of the tube
Take the full sized version of the tube c/p size her down by 35% pull to the bottom right
47 c/p size this down by 35% pull to the bottom left edge of her tail
23 c/p size this down by 25% pull to the middle of her tail
43 c/p size this down by 25% pull to sit in front of her knees
39 c/p size this down by 25% pull to float on far left of the frame
27 c/p size this down by 26% pull to the far right on the tag
19 c/p size this down by 16% pull to the left edge of the tag
17 c/p size this down by 12% pull to the right edge of the water lilies
14 c/p size this down by 12%pull to float about the tower of rocks on right edge of the frame
21 c/p size this down by 19%pull to sit by flower on rocks, on left side of the tag
37 c/p size this down by 12% pul to sit in front of the colored rocks
25 c/p size this down by 15% pull to the left edge of colored rocks
36 c/p size this down by 12% pull to swim on the left edge of the shark
51 c/p size this down by 8% pull to sit on left edge of the rainbow snake
63 c/p size this down by 12% pull to sit by pink snake
64 c/p size this down by 65% then pull up to the middle of your tag
50 c/p size this down by 12% pull to sit on rocks on right edge of the frame
Click on bottom layer of your tag Open paper7 flood fill this layer, then apply mask from above, merge into one raster layer…

CLick on top most layer of your tag, add a new raster for the copyrights for tube, kit maker and add  

Thank you for reading my tutorial 

©LadyDragus

** when showing off a tag you make with this tutorial only use the copyright for the tag you are using and credit to the kit maker, Never put copyright and my tutorial link, this is against any artist TOU Thank you for understanding **

 Tag for kit maker

 Here are some more freebies

These are AI papers 

 My new kit 

Matches the tube by Rebecca Sinz

Called Longing Fairy