I am making a 3 piece set

Avatar 150x150

Sig 600x300

Sig Tag 600x600

Be easy my first try at this..

Open paper 3 flood fill all 3 pieces

This next step will all depend on what tube you are using I’m using one with two size’s in it…

I’m taking it on the sig and pulling it to the far left hand of the sig.

On the Sig Tag I’m pasting it as a layer in the middle (we will use a mask on this in  a bit)

Apply mask RebelDezing Mask-May30th you have to have been a member of her froum

You can join that here Rebel Dezigns Froum

Open rs-birdhouse1 and re-size it by 60% you will use the same size on the Sig-tag and the Sig .. on the sig you will pull it to the far right hand side of the tag..
on the bigger tag you will pull it to the left hand side of the tag

Open rs-fox and re-size it by 40% and pull it to the front of the bird house on the Sig-tag

On the Sig (600x300) you will re-size it by 30% and move it to the right hand side in front of birdhouse…

On the sig tag, you will open rx-pinecone1 and paste as a new layer and re-size it by 25% and pulling it to the upper top right corner of the mask layer…We are not using this element on the smaller tag…

On the sig open deadgrass1 and paste it behind the tube and using your opacity make it 50% just enough to see the blades of grass but not over power the background…

On the sig tag open Leaf10 paste as a new layer over the birdhouse, and re-size by 45% and make the fox’s feet on the edge of the leaf, so it looks like his paw’s are holding it down…

Open oragnes1 and paste as a new layer, re-size 1^st time by 25% then re-size again by 70% and pull it to the lower right hand side. Copy the (re-sized) orange and paste it on the sig 600x300 by the fox’s feet...

Open Crow1 paste as a new layer, re-size by 25% and sit him on top of the middle orange..

Use this frame and paste it as the upper most layer on your sig..