LadyDragus Art: Amethyst Filigree

Jun 26, 2019

Amethyst Filigree

Wednesday, June 26, 2019 | Edit Post

Amethyst Filigree

This tutorial is written in Corel X5, but any version should work, this is written in hopes you have working knowledge of Paint Shop Pro or other graphics program… this is written by me, never meant to copy or look like your work…

I am using a PTU tube

By Rebecca Sinz

She sells all of her tubes

Here Rebecca Sinz Tubes

I am using a FTU kit

By Mizteeque (her Amethyst BirthStone Kit)

Here MizTeeques

I am using a FTU mask

By Rachel (156-3)

Here (old site still works) Rachel Designs

Open a 725x725 (size down at end)

E50 c/p size down by 60%

Take the close up w/out the gold item paste the tube and size her down by 76% pull to the bottom inside of the frame…

E15 c/p size down by 38% pull to sit just under the hair on the left side of the tag…

E30 c/p size down by 38% pull to the lower right of the tag…

E8 c/p size down by 33% pull to the bottom right of your tube…

E4 c/p size down by 23% pull to the left of white flower…

E5 c/p size down by 23% pull to sit in front of the other 2 flowers…

E6 c/p size down by 30% pull to the left of flowers…

E27 c/p size down by 41% pull to the middle of all the flowers…

E39 c/p size down by 45% pull to sit on the far left of the tag…

E54 c/p size down by 25% pull to sit on top of geode …

Go to bottom layer of your tag flood fill with paper7 apply mask from above merge into on raster layer “group”

Go to the top most layer of your tag and add a new raster layer for your credits for kit maker and artist, make sure you have a valid LIC# for this artist…

Thank you for reading my tutorial I hope you enjoyed it

Tag for kit maker and mask maker