Christmas Wishes’

This tutorial was written by me, from my own thoughts and words. It is written in Corel X5, but any version should do. It is also written in hope’s you have a working knowledge of Paint Shop Pro or other graphics program…

I am using a PTU Kit

By

Crystals Creations

Called Christmas Wish

Crystal sells at a few store, you can find them all listed on her blog

Here

 Crystals Creations

I am using the PTU artwork of

Barbara Jensen out of a Single layer pack

Santa’s Girl 2 Close up

You can find all of her artwork in her store

Here Barbara Jensen Tubes

This is a Time line banner tutorial

So you will need a 825x315 size banner to make this tag…

Raster 1 flood fill with paper 11

EE16 c/p re-size by 45% pull to the middle of the tag…

Take the raster layer with the hat on the tube, and paste and mirror pull to the far right hand edge of your tag…

EE13 c/p pull to where the right side of snow is on the very edge of the tube…

EE8 c/p pull it to the bottom edge of banner…

EE44 c/p re-size by 50% pull to the far left hand edge of your banner…

EE6 c/p mirror re-size by 35% pull to the right of the Christmas tree…

EE7 c/p re-size by 45% pull to the far left hand side of tag, you will need to move the tree and sled over to the right some…

EE17 c/p re-size by 20% pull to the left hand edge of sled…

EE25 c/p mirror re-size by 25% pull to the far right hand edge of sled…

EE9 c/p pull to the bottom right edge of tag so it covers the tubes’ shoulders…

EE45 c/p re-size by 30% pull to lower right hand edge of your tag…

Thank you for reading my tutorial

Here is a free time line banner also