Ah Snow Fairy 

This tutorial is written in Corel X5, but any version should work.

I am using a PTU Kit

By Black Widow’s Creationz

Called

Ice Princess

She sells at many stores, you can find them all on her blog

Here  Black Widow Cerationz

I am using the wicked artwork of

Tony Tzanoukakis

You can find all of his work in his store

HereThe art of Tony T

I am using a FTU mask by Dee

Of Dangerously Delicious Designz

Dee~ Dangerously Delicious Designz 

I am using the Font Penguin Attack

You can find this on most FTU font sites..

Make a 700x700 tags you can always re-size it later

EL24 c/p re-size by 75% take your tube and paste it behind (close up would work) make sure only her face is behind the frame…

EL4 c/p mirror re-size by 50% pull to the far left hand edge of your tag…

EL5 c/p re-size by 50% pull to the middle of tree…

EL23 c/p re-size by 50% pull to put the top skate on the far ball of snowman…

EL42 c/p mirror pull to the far right hand edge of your tag…

E22 c/p re-size by 60% add a sharpen more to the element pull to lower part of other leaves…

EL40 c/p mirror pull to the middle of leaves…

EL46 c/p re-size by 75% add a sharpen more then pull to the lower right hand edge of your tag…

EL15 c/p re-size by 40% pull to the middle bottom of bow…

E12 c/p re-size by 50% pull to cover the bottom of ornament…

EL27 c/p re-size by 50% pull to the bottom of ornament in between the other snowballs…

EL18 c/p mirror re-size by 50% pull to the left hand edge of ornament over the snowballs…

EL41 c/p mirror re-size by 50% pull to the lower left hand edge snowballs…

EL48 c/p mirror re-size by 25% pull to the far right hand edge of your tag…

Now take the 2^nd tube you are using “Frost Fairy” re-size it to fit on the left hand edge of your tag, I normally make a smaller version of tag(600pixels in height), and then I re-sized her by 80% pull to the far left hand edge of your tag…

EL12 c/p re-size by 65% pull to cover the frost fairy tube…

EL13 c/p re-size by 50% pull to cover the bottom edge of your tag…

EL31 c/p re-size by 25% pull to make the tube look like she is holding it in her hand then add this drop shadow

Vertical 5

Horizontal 3

Opacity 70

Blur 5

Color black

Go to the bottom layer of your tag, flood fill with paper18 mask from above, merge into one layer add the drop shadow from above but instead of black as your color make it white…

Take EL1 c/p re-size by 50% paste it over mask, then do it 3 or 4 times more to see the snowflakes all over the mask layer…. 

Go back to top most layer of your tag, make a whole new raster layer for your copyright of the tube and give the kit maker credit if she requires it.

Thank you for reading/doing my tutorial

LadyDragus 11-19-15©

Tag for kit maker and mask maker